Compare the complete model, regional suffix and label.
Kärcher
Puzzi 10/1
Assemble the product, fit the correct cleaning accessory and verify that filters, tanks and safety latches are seated.
English: Product names, model codes, official notices and manufacturer text remain in the language of the authoritative source. EgoFile interface content is translated.
What this page contains
- Record type
- Manufacturer manual
- Responsible source
- Manufacturer / official support centre
- Verification
- Catalogued source
- Source evidence
- OEM document or official support page
- Last source check
- 1 August 2026
- Indexing policy
- Page is eligible for indexing
Confirm the document scope and regional variant against the rating label.
Link to the document ownerOne product. Everything in one place.
Manufacturer manual. Confirm the complete rating-label code before saving a serial number or following variant-specific instructions.
Keep warranty, history and safety alerts together.
Use cited guidance or create a private EgoFile case.
Before first use
- Install the handle, hose, battery or cleaning head.
- Fit clean filters and fill only approved tanks.
- Test the controls on a small suitable surface.
Operate the product correctly
- Choose the accessory and power level for the surface.
- Keep airflow paths and rollers free of obstructions.
- Empty dirt or wastewater before the maximum mark.
Important precautions
- Disconnect power before clearing blockages.
- Do not collect hot ash, flammable liquid or sharp debris unless approved.
- Keep water away from non-wet-rated electrical parts.
Maintain reliable operation
- Empty containers and rinse washable parts after use.
- Remove hair and fibres from rollers.
- Dry filters completely before refitting.
What the product may be indicating
These are general diagnostic paths for this product category. Error-code numbers differ between brands, markets and revisions, so EgoFile shows a code only after it is confirmed in the exact official manual.
No spray, steam or solution flow
Medium priorityWhat it means: A tank, cap, nozzle or supply path may be empty or obstructed.
First safe check: Refill with the approved liquid and reseat all removable tanks and caps.
Stop condition: Do not open a pressurised or hot system.
Poor water or dirt pickup
Low priorityWhat it means: The recovery tank, filter, seal or nozzle may need cleaning.
First safe check: Empty the tank and clean user-removable filters and channels.
Stop condition: Stop if liquid reaches a non-wet-rated electrical area.
Pressure or steam drops
High priorityWhat it means: The inlet, nozzle, filter or scale level may restrict output.
First safe check: Switch off, depressurise or cool as instructed, then clean approved parts.
Stop condition: Never loosen a pressurised fitting; seek service for damaged hoses.
Liquid leaks from the appliance
High priorityWhat it means: A tank, seal, hose or coupling may not be seated or may be damaged.
First safe check: Stop, disconnect safely and reseat accessible containers and couplings.
Stop condition: Do not restart with a damaged pressure hose, cable or housing.
Three additional checks
Use these checks when no error code is displayed.
Low suction
Empty the bin and check filters, hose and floor head.
Brush stopped
Remove wrapped fibres after disconnecting power.
Will not charge
Clean contacts and check the dock, adapter and outlet.
Check recalls separately from the manual.
No exact model match was attached automatically. Search the official safety records by brand, shorter model number or UPC.
Search safety notices →This EgoFile page is a practical quick reference, not a replacement for the complete manufacturer document. Confirm the full model, configuration and regional suffix before installation, operation, repair or safety-critical work.
Manufacturer support →