Compare the complete model, regional suffix and label.
Sony
SRS-XG300
Charge or power the product, pair it with the source device and start with a low listening level.
English: Product names, model codes, official notices and manufacturer text remain in the authoritative source language. EgoFile interface labels are translated.
What this page contains
- Record type
- Instrukcja producenta
- Authority
- Producent / oficjalne centrum wsparcia
- Verification
- Źródło skatalogowane
- Evidence
- Dokument lub strona wsparcia OEM
- Last source check
- 1 sierpnia 2026
- Indexing policy
- Strona może być indeksowana
Zakres i wariant regionalny należy potwierdzić na tabliczce znamionowej.
Odnośnik do właściciela dokumentuOne product. Everything in one place.
Manufacturer manual. Confirm the complete rating-label code before saving a serial number or following variant-specific instructions.
Keep warranty, history and safety alerts together.
Use cited guidance or create a private EgoFile case.
Before first use
- Charge fully or connect the supplied power adapter.
- Enter pairing mode and select the product on the source device.
- Install the companion app and available firmware updates.
Use the product correctly
- Select the correct input or paired device.
- Set a safe volume before playback.
- Use the app for equaliser, controls and multipoint settings.
Important precautions
- Avoid prolonged listening at high volume.
- Keep charging contacts clean and dry.
- Do not use damaged batteries or swollen enclosures.
Keep it working reliably
- Wipe cushions, grilles and charging contacts gently.
- Store in a dry case away from extreme temperatures.
- Update firmware through the official application.
What the product may be telling you
These are category-level diagnostic paths. Error-code numbers differ between brands, markets and revisions, so EgoFile shows a code only after it is confirmed in the exact official manual.
Pairing fails
Low priorityWhat it means: The product may be connected elsewhere or an old pairing record may conflict.
Safe first check: Disconnect other devices, remove the saved pairing and enter pairing mode again.
Stop condition: Use only the documented reset sequence.
Sound cuts out or one channel is silent
Low priorityWhat it means: Distance, interference, balance settings or dirty charging contacts may be involved.
Safe first check: Move closer, check balance, clean dry contacts and fully recharge.
Stop condition: Stop using damaged cables, swollen batteries or wet equipment.
Will not charge
Medium priorityWhat it means: Contacts, cable, adapter, case alignment or temperature may prevent charging.
Safe first check: Clean dry contacts and test the approved cable and power source.
Stop condition: Do not charge a hot, swollen or physically damaged battery.
Firmware update does not complete
Low priorityWhat it means: Battery level, connection stability or the companion app may be responsible.
Safe first check: Recharge both products, keep them close and retry in the official app.
Stop condition: Do not disconnect power during an active update unless instructed.
Three more things to verify
Useful when no error code is visible.
Will not pair
Remove the old pairing record and repeat pairing mode.
Sound cuts out
Reduce distance and wireless interference.
One side is silent
Clean contacts, recharge and reset the product.
Check recalls separately from the manual.
No exact model match was attached automatically. Search the official safety records by brand, shorter model number or UPC.
Search safety notices →This EgoFile page is a practical quick reference, not a replacement for the complete manufacturer document. Confirm the full model, configuration and regional suffix before installation, operation, repair or safety-critical work.
Manufacturer support →